Product Description
This series of products uses polyester resin and epoxy resin as the main base material to make thermosetting powder coating.
Product Features
- Good adhesion, excellent mechanical properties such as impact resistance;
- Good leveling and gloss;
- Strong chemical resistance and corrosion resistance;
- Better heat resistance and light resistance stability than pure epoxy powder.
Special effects
Various wrinkles, metal, pearlescent effects and mixed colors, etc.
Application areas
Suitable for coating of various indoor products, widely used in any indoor purposes such as furniture, household appliances, industrial equipment, sports equipment, toys, hardware machinery, store shelves, lamps, etc.
Transportation packaging
Carton packaging, lined with two layers of polyvinyl chloride plastic bags, net weight of each box is 20kg. Non-hazardous items can be transported in various ways, but should be kept away from direct sunlight, moisture and heat, and contact with chemicals.
Hygiene and safety
Operators should wear dust masks during use to avoid inhaling dust and minimize long-term contact between skin and powder coating. Paint attached to the skin can be washed with soap.
Powder properties
| Specific gravity | 1.4~1.8g/cm3 (depending on the formulation and color) |
| Particle size | Depending on the purpose, the standard type has an average particle size of 35~40 microns, less than 10 microns powder <10%, greater than 100 microns powder <0.5%. |
| Volatile matter | <1% |
| Softening point | 60~95℃ varies depending on the color gloss |
| Storage stability | Epoxy/polyester powder coatings should be stored in a dry, ventilated room below 35℃, and avoid direct sunlight. If stored in an air-conditioned room, the powder must be stored at room temperature or the same (temperature) as the spraying equipment before use to avoid moisture. Under this condition, the powder can be stored stably for 12 months. If it exceeds the period, it must be re-tested. If the result meets the requirements, it can still be used. Note: For low-temperature curing types and powders with a gloss of less than 40% (60°), the storage temperature should be below 30℃. |
Coating properties
| Test items | Inspection standard or method | Inspection index |
| Appearance | Visual inspection | Various board surface effects |
| Impact | GB/T 1732 | ≥50Kg·cm |
| Bending | GB/T 6742 | ≤2mm |
| Cupping | GB/T 9753 | ≥8mm |
| Hardness | GB/T 6739 | ≥H~2H |
| Adhesion | GB/T 9286 | Level 0 |
| Salt spray resistant | GB/T 1771 | 500h; Scribed area: unidirectional rust ≤2.0mm; Unscribed area: no abnormality |
| Moisture and heat resistance | GB/T 1740 | 500h No abnormality |
| Photoaging | Poor light resistance, not recommended for outdoor use | |
| The above coating performance indicators may decrease slightly as the gloss decreases. | ||
| Spraying | This series of products are suitable for the following spraying methods: corona electrostatic spraying; friction electrostatic spraying; electrostatic fluidized bed spraying; fluidized bed hot dip coating. | |
| Coating thickness: Use between 40~150 microns, recommended film thickness is 50~80 microns. Average coverage: 10~12 square meters/kg, film thickness 60 microns (calculated based on 100% usage rate) | ||
| Curing conditions | 200℃/10 minutes is recommended, and it can also be designed according to user needs: 140℃/30 minutes, 160℃/20分钟，180℃/10 minutes, etc. | |
