Знешнія трывалыя поліэфірныя парашковыя пакрыцці MT-610

Surface Finish Options Overview

Апісанне тавару

MT-610 is a range of polyester TGIC Free powder coatings designed for exterior exposure with good weather resistance from just one application. The coatings sustain a longer lifespan and are available in a wide range of colors and finishes which allow your product to shine. MT-610 offers not only beautiful aesthetics but also a performance to match. It is ideally suited to a broad range of outdoor applications including outdoor furniture, playground equipment, signs, fencing, vending machines and general metal finishing. Can also be used for indoor application if required.

Ўласцівасці парашка

папярэдняя апрацоўка

Ацынкаваная сталь патрабуе падрыхтоўкі паверхні шляхам шматступенчатай папярэдняй апрацоўкі з выкарыстаннем фасфату цынку або храмата, альбо кантраляванай дробеструйнай апрацоўкі. У залежнасці ад тыпу ацынкавання можа спатрэбіцца дэгазацыя або выкарыстанне дабавак супраць бурбалак - выконвайце рэкамендацыі пастаўшчыка папярэдняй апрацоўкі. Фасфат жалеза і асабліва цынкавае фасфатаванне чорных металаў паляпшаюць каразійную ўстойлівасць. Алюмініевыя падкладкі могуць запатрабаваць храматавага канверсійнага пакрыцця.

дадатак

Powders can be applied by manual or automatic electrostatic spray equipment. All powders can show small color differences from batch to batch, this is normal and unavoidable. Bonded products have better application properties than blended products (more stable) but attention should still be paid to line settings in order to avoid “marble effect” and changes in aspect after recycling. Products with different codes should not be mixed even if same colour and gloss. Different substrates (aluminium, steel, galvanized steel…), use of primer, and big changes in film thickness may give a different aspect. Applicators and fabricators are advised to use a single batch for parts that will be assembled together. Differences are more likely with special effect powders. A good protection is linked with the recommended film thickness. It is recommended that for consistent application and appearance product be fluidized during application. Clearcoats including tinted clearcoats cannot be applied directly on primers. Only fully opaque shades are suitable for application over primer.

Умовы выпрабаванняў

The results are based on mechanical and chemical tests which (unless otherwise indicated) have been carried out under laboratory conditions and are given for guidance only Testing has been determined under laboratory conditions using the following application properties and is for guidance only.

Механічныя выпрабаванні