পলিয়েস্টার ভিত্তিক পাউডার কোটিং MT-620 AM

Surface Finish Options Overview

পণ্য বিবরণ

MT-620 AM is a series of polyester based powder coatings, formulated without the use of TGIC, designed for the exterior environment, offering the benefits of MT 600 in combination with specific antimicrobial activity. MT-620 AM powders are available in a wide range of colors in gloss, satin, matt, metallic and textured effects and can be custom matched to the user’s requirements.

পাউডার বৈশিষ্ট্য

পরীক্ষা শর্ত

নীচে দেখানো ফলাফলগুলি যান্ত্রিক এবং রাসায়নিক পরীক্ষার উপর ভিত্তি করে তৈরি করা হয়েছে (অন্যথায় নির্দেশিত না হলে) যা পরীক্ষাগারের পরিস্থিতিতে করা হয়েছে এবং শুধুমাত্র নির্দেশনার জন্য দেওয়া হয়েছে। প্রকৃত পণ্যের কার্যকারিতা নির্ভর করবে পণ্যটি কোন পরিস্থিতিতে ব্যবহৃত হচ্ছে তার উপর।

যান্ত্রিক পরীক্ষা

pretreatment

Aluminium, steel or Zintec surfaces to be coated must be clean and free from grease. Iron phosphate and particularly lightweight zinc phosphating of ferrous metals improves corrosion resistance. Aluminium substrates may require a chromate conversion coating. Detailed advice should be sought from the pre-treatment supplier.

আবেদন

MT-620 AM powder coatings can be applied by corona electrostatic equipment. In all application processes the aspect obtained is subject to variation, depending on the method of application (type of gun, nozzle, etc) and the shape/type of component. We recommend that the actual application parameters are adapted and adjusted depending on the type of component and with each powder batch to give a finish in accordance with our color card. The following procedure is given as a guideline when using these finishes. We recommend the use of flat jet spray nozzles. To ensure powder homogeneity, the complete content of the boxes should be emptied completely into the feed hopper. For manual application it is essential to ensure that an even film thickness is applied, and, in all Instances, sinusoidal gun movements should be avoided. All powders can show small color differences from batch to batch, this is normal and unavoidable. Applicators and fabricators are advised to use a single batch for parts that will be assembled together. Differences are more likely with special effect powders. Bonded products have better application properties than blended products (more stable) but attention should still be paid to line settings to avoid “marble effect” and changes in aspect after recycling. Different substrates (Aluminium, steel, galvanized steel, etc.), use of primer, and big changes in film thickness may give a different aspect. Products with different codes should not be mixed even if same color and gloss.