Recobriments exteriors en pols de polièster duradors amb tecnologia antimicrobiana MT-610 AM

Surface Finish Options Overview

Descripció del producte

MT-610 AM is a range of polyester TGIC Free powder coatings designed for exterior exposure with good weather resistance from just one application with specific antimicrobial activity. The coatings sustain a longer lifespan and are available in a wide range of colors and finishes which allow your product to shine. Additionally,MT-610 AM uses antimicrobial technology to reduce the number of microbes such as bacteria and mold. Test results have proven a reduction of bacteria and mold up to 99.9%.

MT-610 AM offers not only beautiful aesthetics but also a performance to match. It is ideally suited to a broad range of outdoor applications including outdoor furniture, playground equipment, signs, fencing, vending machines and general metal finishing. Can also be used for indoor application if required.

Propietats de la pols

Pre-tractament

Galvanised steel requires surface preparation by either multi-stage pretreatment using either zinc phosphate or chromate conversion or controlled sweep blasting. Depending on the type of galvanizing, degassing or use of anti-bubbling additives may be required – follow the procedural advice of the pretreatment supplier. Iron phosphate and particularly Zinc phosphating of ferrous metals improves corrosion resistance. Aluminium substrates may require a chromate conversion coating.

Sol·licitud

Powders can be applied by manual or automatic electrostatic spray equipment. A good protection is linked with the recommended film thickness. All powders can show small color differences from batch to batch, this is normal and unavoidable. Applicators and fabricators are advised to use a single batch for parts that will be assembled together. Differences are more likely with special effect powders. Bonded products have better application properties than blended products (more stable) but attention should still be paid to line settings in order to avoid “marble effect” and changes in aspect after recycling. Different substrates (aluminium, steel, galvanized steel…), use of primer, and big changes in film thickness may give a different aspect. Products with different codes should not be mixed even if same colour and gloss. It is recommended that for consistent application and appearance product be fluidized during application.

Condicions de prova

Actual product performance will depend upon the circumstances under which the product is used. Testing has been determined under laboratory conditions using the following application properties and is for guidance only.

Assajos mecànics