MT-PZ is a powder coating primer containing zinc which is designed to give enhanced corrosion protection of mild steel. This duplex system combines cathodic protection and barrier effect. Dedicated to steel protection with a surface pre-treatment obtained by grit/shot blasting. MT-PZ is based on a specific epoxy zinc rich formulation that brings conductivity to enable the cathodic protection. MT- PZ includes a specific anticorrosive function which improves the protection in case of scratch. Qualisteelcoat approval: Base Material: Steel PE-0097 2 coat system – up to C4-H, mechanical pretreatment.
| 화학물질 종류 | Thermosetting epoxy |
| 외관 | 부드럽게 |
| Gloss level(60°) | 45-65단위 |
| 색상 | Grey (about RAL7012) |
| Recommended Film Thickness (µm) | 70 – 120μm |
| 밀도 (g / cm3) | 2.1g / cm³ |
| 어플리케이션 | 정전기 |
| 스토리지 | Under dry, cool (≤ 30°C) conditions |
| 유통 기한 | 12개월 25°C 이하 |
Surface preparation depends upon the metal, the type of surface, its conditions and the required performance. See our recommendation for pretreatment to be used with MT-PZ.
| 기판 | Mechanical pretreatment | Chemical pretreatment |
| 마일드 스틸 | Grit Blasting Sa 2.5 in accordance with ISO NF EN 8501-1. Roughness: Rz 35 60 µm / Ra 6-12 µm | 금지 |
| 캐스트 스틸 | ||
| Electro Zinc steel | 금지 | |
| 용융 아연 도금 강판 | ||
| Zinc sprayed (gas flame/electrical deposition) |
MT-PZ is suitable for corona electrostatic spraying. Tribo application is not recommended.
| 응용 프로그램 설정 | Fluidizing air pressure: 1.5kg/cm2 initially then 1kg/cm2 Transport air pressure: 0.5 to 0.8 kg/cm Recommended voltage: 65 to 70kV |
| Curing limits | Primer should be cured, or at least gelled, using the recommended curing schedules, before application of the topcoat. The object temperature must not be below 110°C or above 180°C. The primer should be cured in a convection oven, optionally with infra-red heaters, with air temperature not exceeding 180°C. |
| 권장 필름 두께 | 70-120 µm A good protection is linked with the recommended film thickness. |
| 재활용 | Trials, with suitable recycling equipment, must be carried out before commencing production. Attention should be paid to the ratio of new powder, a minimum of 70% must be used. Gun nozzles must be cleaned every 30 minutes. |
For help with solutions customized to your business needs, contact Export Director now.
Export Director
With 20+ years of experience and We firmly believe that product quality is the basis of cooperation.
Send Inquiry
TEl
+86-21-6420 0566
